TREAD ROLLERS: 1.9" dia. x 16 ga. steel, model 196S grooved.

DRIVE BELT: 3/16" dia., polyurethane belts. Nominal 15 lbs. per roller drive.

DRIVE SHAFT: 1" dia. C1018 cold rolled steel shaft.

COUPLINGS: Couplings located on horizonal section only

LIFT: Gas cylinder provides assist for raising/lowering.

BED: 4-1/2 " x 1-1/2" x 10 ga. formed steel channel frameon actual lift gate; 7" x 1-1/2" x 12 ga. on horizonal section.

BEARINGS: Precision, lubricated, ball bearing units with composite housings.

FLOOR SUPPORTS: Optional

MOTOR DRIVE: Unit is designed to be driven by 796LS.

SPECIFY HAND: Specify if gate is left or right hand.