TREAD ROLLERS: 1.9" dia. x 16 ga. steel, model 196S grooved.
DRIVE BELT: 3/16" dia., polyurethane belts. Nominal 15 lbs. per roller drive.
DRIVE SHAFT: 1" dia. C1018 cold rolled steel shaft.
COUPLINGS: Couplings located both ends (type "A"), one end only (type "B" or "C") or none (type "D").
CENTER DRIVE: Located approximately 16-1/2" from end of bed section on 4" RC; 18" on 3" and 6" RC.
SPEED: 60 FPM, constant.
ACCUMULATION ZONE: Zone singulation operation; 2'-0" zone length, photoeye controlled.
BEARINGS: All bearings are precision, lubricated, ball bearing units with composite housings.
|
|
BED: 7" x 1-1/2" x 12 ga. formed steel channel frame. Bed sections attached with splice plates and floor supports.
FLOOR SUPPORTS: Optional.
FRL: Unit is provided with filter, regulator, lubricator with 1/4" ports.
MOTOR DRIVE: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor.
ROLLER CHAIN: Drive shaft is driven by No. 50 chain. Chain take-up provided on motor base.
CAPACITY: See technical section for load capacity rating.
ELECTRICAL CONTROLS: Optional
|
